Description
W6100-EVB-Pico is a microcontroller evaluation board based on the Raspberry Pi RP2040 and fully hardwired TCP/IP controller W6100 – and basically works the same as Raspberry Pi Pico board but with additional Ethernet via W6100.
Features
- RP2040 microcontroller with 2 MByte Flash
- Dual-core cortex M0+ at up to 133 MHz
- 264 kByte multi-bank high performance SRAM
- External Quad-SPI Flash with eXecute In Place (XIP)
- High performance full-crossbar bus fabric
- 30 multi-function General Purpose I/O (4 can be used for ADC)
- 1.8-3.3 V I/O voltage (Note: Pico I/O voltage is fixed at 3.3 V)
- 12-bit 500 ksps Analogue to Digital Converter (ADC)
- Various digital peripherals
- 2x UART, 2x I²C, 2x SPI, 16x PWM channels
- 1x Timer with 4 alarms, 1x Real Time Counter
- 2x Programmable IO (PIO) blocks, 8 state machines total
- Flexible, user-programmable high-speed I/O
- Can emulate interfaces such as SD card and VGA
- Includes W6100
- Supports Hardwired Internet Protocols: TCP, UDP, IPv6, IPv4, ICMPv6, ICMPv4, IGMP, MLDv1, ARP, PPPoE
- Supports 8 independent SOCKETs simultaneously with 32 KB memory
- Internal 16 Kbytes Memory for TX/RX Buffers
- SPI Interface
- Micro-USB B port for power and data (and for reprogramming the Flash)
- 40-pin 21x51 ‘DIP’ style 1 mm thick PCB with 0.1' through-hole pins also with edge castellations
- 3-pin ARM Serial Wire Debug (SWD) port
- 10 / 100 Ethernet PHY embedded
- Supports Auto Negotiation
- Full / Half Duplex
- 10 / 100 Based
- Built-in RJ45 (RB1-125BAG1A)
- Built-in LDO (LM8805SF5-33V)
Downloads
