Great Scott Gadgets HackRF One SDR + Opera Cake Antenna Switch (Bundle)

  • BrandGreat Scott Gadgets

Description

HackRF One Software Defined Radio

HackRF One is a Software Defined Radio (SDR) peripheral capable of transmission or reception of radio signals from 1 MHz to 6 GHz. Designed to enable test and development of modern and next generation radio technologies, HackRF One is an open source hardware platform that can be used as a USB peripheral or programmed for stand-alone operation.

Specifications

  • 1 MHz to 6 GHz operating frequency
  • Half-duplex transceiver
  • Up to 20 million samples per second
  • 8-bit quadrature samples (8-bit I and 8-bit Q)
  • Compatible with GNU Radio, SDR and more
  • Software-configurable RX and TX gain and baseband filter
  • Software-controlled antenna port power (50 mA at 3.3 V)
  • SMA female antenna connector
  • SMA female clock input and output for synchronization
  • Convenient buttons for programming
  • Internal pin headers for expansion
  • Hi-Speed USB 2.0
  • USB-powered
  • Open source hardware

HackRF One is test equipment for RF systems. It has not been tested for compliance with regulations governing transmission of radio signals. You are responsible for using your HackRF One legally.

Note: An antenna is not included. ANT500 is recommended as a starter antenna for HackRF One.

Documentation/Software


Opera Cake Antenna Switch for HackRF One

Opera Cake is an antenna switching add-on board for HackRF One that is configured with command-line software either manually, or for automated port switching based on frequency or time. It has two primary ports, each connected to any of eight secondary ports, and is optimized for use as a pair of 1x4 switches or as a single 1x8 switch. Its recommended frequency range is 1 MHz to 4 GHz.

When HackRF One is used to transmit, Opera Cake can automatically route its output to the appropriate transmit antennas, as well as any external filters, amplifiers, etc. No changes are needed to the existing SDR software, but full control from the host is available.

Opera Cake also enhances the HackRF One’s use as a spectrum analyzer across its entire operating frequency range of 1 MHz to 4 GHz. Antenna switching works with the existing hackrf_sweep feature, which can sweep the whole tuning range in less than a second. Automatic switching mid-sweep enables the use of multiple antennas when sweeping a wide frequency range.

Downloads


Bundle Contents

  • 1x HackRF One SDR
  • 1x Injection molded plastic enclosure
  • 1x micro-USB cable
  • 1x Opera Cake Antenna Switch
Product form

HackRF One Software Defined Radio HackRF One is a Software Defined Radio (SDR) peripheral capable of transmission or reception of... Read more

No reviews

€ 538,95€ 449,00 incl. VAT
Members identical

      Details

      SKU: 20441
      EAN: 020441

      Description

      HackRF One Software Defined Radio

      HackRF One is a Software Defined Radio (SDR) peripheral capable of transmission or reception of radio signals from 1 MHz to 6 GHz. Designed to enable test and development of modern and next generation radio technologies, HackRF One is an open source hardware platform that can be used as a USB peripheral or programmed for stand-alone operation.

      Specifications

      • 1 MHz to 6 GHz operating frequency
      • Half-duplex transceiver
      • Up to 20 million samples per second
      • 8-bit quadrature samples (8-bit I and 8-bit Q)
      • Compatible with GNU Radio, SDR and more
      • Software-configurable RX and TX gain and baseband filter
      • Software-controlled antenna port power (50 mA at 3.3 V)
      • SMA female antenna connector
      • SMA female clock input and output for synchronization
      • Convenient buttons for programming
      • Internal pin headers for expansion
      • Hi-Speed USB 2.0
      • USB-powered
      • Open source hardware

      HackRF One is test equipment for RF systems. It has not been tested for compliance with regulations governing transmission of radio signals. You are responsible for using your HackRF One legally.

      Note: An antenna is not included. ANT500 is recommended as a starter antenna for HackRF One.

      Documentation/Software


      Opera Cake Antenna Switch for HackRF One

      Opera Cake is an antenna switching add-on board for HackRF One that is configured with command-line software either manually, or for automated port switching based on frequency or time. It has two primary ports, each connected to any of eight secondary ports, and is optimized for use as a pair of 1x4 switches or as a single 1x8 switch. Its recommended frequency range is 1 MHz to 4 GHz.

      When HackRF One is used to transmit, Opera Cake can automatically route its output to the appropriate transmit antennas, as well as any external filters, amplifiers, etc. No changes are needed to the existing SDR software, but full control from the host is available.

      Opera Cake also enhances the HackRF One’s use as a spectrum analyzer across its entire operating frequency range of 1 MHz to 4 GHz. Antenna switching works with the existing hackrf_sweep feature, which can sweep the whole tuning range in less than a second. Automatic switching mid-sweep enables the use of multiple antennas when sweeping a wide frequency range.

      Downloads


      Bundle Contents

      • 1x HackRF One SDR
      • 1x Injection molded plastic enclosure
      • 1x micro-USB cable
      • 1x Opera Cake Antenna Switch

      Reviews

      Great Scott Gadgets HackRF One SDR + Opera Cake Antenneschakelaar (Bundel)

      Great Scott Gadgets HackRF One SDR + Opera Cake Antenna Switch (Bundle)

      0 out of 5 stars

      This product has no reviews yet

      Recently viewed products

      Login

      Forgot password?

      Don't have an account yet?
      Create an account