Infineon High-Side Switch Shield with BTS7002-1EPP
Overview
This Arduino shield comes with four high side switches BTS7002-1EPP. For demonstrating relay and fuse replacement, the shield can be used to control and protect outputs of a 12 V supply, turn ON/OFF loads, measure the load current, and detect the no-load condition.
The shield can be used in stand-alone mode or controlled either by an Arduino board, or the ARM® powered Infineon XMC™ microcontroller kits using the Arduino form factor.
Overview
This Arduino shield comes with four high side switches BTS7002-1EPP. For demonstrating relay and fuse replacement, the shield can be used to control and protect outputs of a 12 V supply, turn ON/OFF loads, measure the load current, and detect the no-load condition.
The shield can be used in stand-alone mode or controlled either by an Arduino board, or the ARM® powered Infineon XMC™ microcontroller kits using the Arduino form factor.
Details
Features
- High current sense accuracy
- Lowest RDS (ON) on small footprint 2 mΩ – 8 mΩ in TSDSO-14
- Miniaturization / Shrink of the PCB Area
- Protection concept with a current trip and intelligent latch
- Simplified & cost-efficient ground network
- 50% reduced internal operating current consumption
- Benchmark cranking voltage capability able to work down to 3.1 V
- Very low output leakage current
- Current sense accuracy ≤ 5% @ nominal load current
- Smaller package size for area savings
Target Applications
- Suitable for driving heating loads and general power distribution
- Replaces electromechanical relays, fuses and discrete circuits
- Suitable for driving up to 20 A resistive, inductive, capacitive loads
SHIELD_BTS7002-1EPP | |
---|---|
Dimensions | 59.7 mm x 53.4 mm |
Input Type | DC |
Interfaces | Arduino footprint |
Qualification | Automotive |
Supply Voltage Range | -16 V - 35 V |
Topology | High-side switch |
Type | Demo Board |
Specifications
SKU | 19025 |
---|---|
Manufacturer | Infineon |