Home › Magazines › 2002 › December › Modified Time Clock Switch

Modified Time Clock Switch

Published in issue 316, December 2002

It doesn’t take a lot of effort to convert an electromechanical time clock switch into a simple time switch, and it can be done quite simply. All you have to do is open the case and disconnect the series resistor for the motor from the switch contact. Next, use a length of insulated wire to reconnect it to the other side of the switch contact. The difference between the two versions is shown in the figure.

Click below to download a PDF copy of this article from Elektor magazine.

 

Downloads 

PDF Article (e02ch08.pdf)
10 Elektor Credits
Please note. In view of the complexity of international markets, Elektor cannot guarantee the availability of components for this project.

Subscribe now

Subscribe to our free
E-weekly Newsletter!

Enter your Email address:

Follow Elektor

      

Act now!

FAQ

Before submitting questions, review our FAQ section!

Bestseller

Microprocessor Design using Verilog HDL

This book is a practical guide to processor design in the real world. It presents the Verilog HDL in an easily digestible fashion and serves as a thorough introduction about reducing a computer architecture and instruction set to practice. 

Package Deals

Elektor Bundles

Check our Package Deals and save money! Discounts up to 19% now available!

Price Slashed

Elektor OSPV

This Open Source People Vehicle is perfect for factory halls, warehouses, hospitals, colleges, schools etc.

Elektor PCBs at 25% OFF