Home › Magazines › 2000 › July › Opto-Isolated RS232 Interface

Opto-Isolated RS232 Interface

Published in issue 290, July 2000

This design is for a simple half-duplex optically isolated interface that converts a 20 mA current loop (connected to J2) into an RS232 signal (on J1) which can be monitored by, say, a laptop PC. In the author’s case, the system operates at 1200 baud. The signal to be monitored should be a fully digital on-off communications signal, rather than the usual 4/20 mA (industrial) analogue transmission standard.

Click below to download a PDF copy of this article from Elektor magazine.

 

Downloads 

PDF Article (E007053.pdf)
10 Elektor Credits
Please note. In view of the complexity of international markets, Elektor cannot guarantee the availability of components for this project.

Subscribe now

Subscribe to our free
E-weekly Newsletter!

Enter your Email address:

Follow Elektor

      

Act now!

FAQ

Before submitting questions, review our FAQ section!

Bestseller

Microprocessor Design using Verilog HDL

This book is a practical guide to processor design in the real world. It presents the Verilog HDL in an easily digestible fashion and serves as a thorough introduction about reducing a computer architecture and instruction set to practice. 

Package Deals

Elektor Bundles

Check our Package Deals and save money! Discounts up to 19% now available!

Price Slashed

Elektor OSPV

This Open Source People Vehicle is perfect for factory halls, warehouses, hospitals, colleges, schools etc.

Elektor PCBs at 25% OFF