ELEKTOR FORUMS

Hey.

Im doing a project where im trying the make a interface with the TX/RX on the ATmega32. I was just woundering if it would have any effect on the circut or timing if the crystal was changed out? Im communicating with 115200 baud, and with a 16MHZ clock i get a error of 3 %.

Regards.

Lars Sauer
DTU - Denmark

Nice job hehe.. good to see some cool Wheelie geeking

Im making the wheelie connect to a robot platform we are using. And for this im adding encoders to the wheels. The encoder information and other informations are transmitted over a rs485 bus. So the baud rate is fixed at 115200.

ill post some pictures and stuff if u like when done

And thx for your reply... Its quiet nice what you have done.

Regards

Lars
DTU.