I seem to have it all working as has been discussed on the forum, with the static address 192.168.0.151, but I keep getting an error "Illegal instruction -- PC = 0x00005EBE" sent to the serial port. Is this normal?
This message is cause by an exception interrupt when the MCU tries to execute an unknown assembly instruction. PC referrers to the program counter that identifies exactly which line of the program caused the error.
This is probably caused by a bit of code that was written for a different processor but was left in the digibutler code. The only way to find out exactly would be to debug with the TBLCF.
If the digibutler is working fine I would not worry about this.
Post edited by jart
on 05-09-2008 13:53