ELEKTOR FORUMS

Hi all,

I am not able having the firmware correcly programmed into the TBLCF interface.
The ICP drivers are installed correctly (manual steps 1..5) and my PC recognises the interface. Using the manual (page 16, step 6) and the TBLCF_BT tool, the first part, programming the boot sector, looks fine. Programming the first block shows already the following error.

D:\>tblcf_bt.exe -B tblcf.abs.s19
Turbo BDM Light ColdFire Bootloader ver 1.0. Compiled on May 23 2006, 08:33:37.
S-rec: "D:\Documents\projects\bdm_cf\sw.jb16\tblcf_firmware\bin\tblcf.abs"
found 5 busses
found 1 HC08JB16 ICP device(s)
Boot sector content identical, -B option ignored
Erasing block at adress:0xF800
Programming block from 0xBA00 to 0xCC74
USB communication problem or programming failure

I assume the USB is working correctly as it was possible to verify the boot sector. One difference between the manual and above is that it tries to program to address 0xCC74. The manual shows 0xCD5A.

Who recognises this or has an idea?
Thanks in advance.